Fujitsu Oracle SPARC M12-2 User Manual

------------------------------------------------------------------------------
Maintenance/Replacement Menu
Please select a FRU to be replaced.
No. FRU Status
--- ------------------- --------------
1 /BB#0/FANU#0 Faulted
2 /BB#0/FANU#1 Normal
3 /BB#0/FANU#2 Normal
4 /BB#0/FANU#3 Normal
5 /BB#0/FANU#4 Normal
6 /BB#0/FANU#5 Normal
7 /BB#0/FANU#6 Normal
8 /BB#0/FANU#7 Normal
------------------------------------------------------------------------------
Select [1-8|b:back] :
1
You are about to replace BB#0/FANU#0.
Do you want to continue?[r:replace|c:cancel] :
r
Please execute the following steps:
1) Confirm the Check LED is blinking.
2) Remove BB#0/FANU#0.
3) Execute either the following:
3-1) After installing the exchanged device, please select 'finish'.
3-2) If you want to suspend the maintenance without exchanging device,
please select 'cancel'.
[f:finish|c:cancel] :
XSCF>
replacefru
Enter "1" since a fault has been confirmed in FANU#0 of BB#0.
6.
Confirm that the selected FRU is displayed, and then enter "r".
7.
Remove the FANU to be replaced, as instructed in the output message.
Do not enter "f" until you mount the replacement FANU.
After mounting the replacement FANU, incorporate it
into the SPARC M12-2/M12-2S
by using the procedure described in "10.4.2 Incorporating the FANU."
9.6.3 Releasing the PSU
This section describes the procedure for releasing the PSU of the SPARC M12.
1.
Log in to the XSCF shell.
2.
Execute the replacefru command to display the maintenance menu.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023314

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English