Fujitsu Oracle SPARC M12-2 User Manual

XSCF>
showpcl -p 1
PPAR-ID LSB PSB Status
01 Powered Off
00 01-0
01 02-0
XSCF>
diagxbu -y -b 03 -t 01 -t 02
XBU diagnosis is about to start, Continue?[y|n] :
y
Power on sequence started. [7200sec]
0..... 30..... 60..... 90.....120end
XBU diagnosis started. [7200sec]
0..... 30..... 60..... 90.....120end
completed.
Power off sequence started. [1200sec]
0.....
30..... 60..... 90.....120end
completed.
*Note*
Please confirm the error of XBU by "showlogs error".
In addition, please confirm the degraded of XBU by "showstatus".
XSCF>
showstatus
XSCF>
(2) Incorporation destination PPAR is stopped (inactive addition)
The following execution example diagnoses the XBU and crossbar cable between the
SPARC M12-2S of BB#3 and the SPARC M12-2S of BB#1 and BB#2 contained in
PPAR#1, which is the incorporation destination.
The hardware diagnosis that is run during the execution of the replacefru command
does not cover the crossbar cable.
If you have released the SPARC M12-2S from the
building block configuration by using the replacefru command, wait until the
replacefru command ends, and then diagnose the crossbar cable by using the
diagxbu command.
10.5.3 Checking the FRU Status After Maintenance
This section describes the procedure for confirming that the FRU is operating
normally after the completion of maintenance.
1.
Log in to the XSCF shell.
2.
Check the hardware status.
The following execution example checks the result output by the showstatus
command. If the hardware is normal, the command displays nothing.
3.
Confirm that
no error is displayed.
In the following execution example, the showlogs command is entered with the
error option to check that no error has occurred in the target SPARC M12-2/
M12-2S since the start of maintenance.
Chapter 10 Setting Up the System 351

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English