Fujitsu Oracle SPARC M12-2 User Manual

Table 5-24
System-Stopped/Cold Addition Procedure of the CMUU
Work
Order
Task Reference
1 Powering off all physical partitions "9.5.2 Stopping All Physical Partitions"
2 Switching the mode switch on the OPNL
to Service
"2.3.2 OPNL Control Function"
3Removing the power cords of all the
SPARC M12-2/M12-2S units
"9.8.2 Removing the Power Cords"
4Removing the filler unit from the SPARC
M12-2/M12-2S
"17.4 Removing the CMU or
Memory"
5 Installing the CMUU in the SPARC
M12-2/M12-2S (*1)
"17.5 Installing the CMU and Memory"
6 Connecting the power cords of all the
SPARC M12-2/M12-2S units
"10.1.1 Installing a Power Cord"
7 Diagnosing all the SPARC M12-2/M12-2S
units
"10.5.1 Diagnosing the SPARC M12
Hardware"
8 Confirming that there is no problem with
the added
CMUU
"10.5.3 Checking the FRU Status After
Maintenance"
9 Switching the mode switch on the OPNL
to Locked
"2.3.2 OPNL Control Function"
10 Powering on all physical partitions "10.9.1 Starting the System With an
XSCF Command"
11 Assigning resources to a logical domain "3.2 Operations and Commands Related
to Logical Domain Configurations" in the
Fujitsu
SPARC M12 and Fujitsu
M10/SPARC M10 Domain Configuration
Guide
*1 If the CMUU has no memory installed, install memory before installing the CMUU in the SPARC M12-2/
M12-2S.
5.6.4 System-Stopped/Cold Addition Workflow of
Memory
You can perform system-stopped/cold addition of memory in the following
configuration:
■
Configuration connecting two or more SPARC M12-2S units to a physical partition
Before adding memory, see "Precautions for memory expansion" in "7.2 Precautions
for FRU Expansion."
Table 5-25 shows the workflow for system-stopped/cold addition of memory.
Chapter 5 FRU Addition Workflows 183

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English