Fujitsu Oracle SPARC M12-2 User Manual

XSCF>
showpparstatus -a
PPAR-ID PPAR Status
00 Running
XSCF>
XSCF>
showpparstatus -a
PPAR-ID PPAR Status
00 Powered Off
01 Powered Off
XSCF>
PPAR-ID#00 is running.
For details on the operation status, see the Fujitsu SPARC M12 and Fujitsu
M10/SPARC M10 XSCF Reference Manual of the XSCF firmware version used.
10.9 Starting the System
This section describes the procedure for starting all the physical partitions of the
system.
You can start the system in the following two ways:
■
Starting the System With an XSCF Command
■
Starting the System From the OPNL
10.9.1 Starting the System With an XSCF Command
This procedure assumes that you start the system from a remote location or in some
other environment where you cannot check the status with the LEDs.
For details on the commands used here, see the Fujitsu SPARC M12 and Fujitsu
M10/SPARC M10 XSCF Reference Manual of the XSCF firmware version used.
1.
Check the operation status of the physical partitions.
Log in to the XSCF shell, and check the operation status of the physical partition
by using the showpparstatus command.
This example checks that PPAR-ID#00 and PPAR-ID#01 are powered off.
2.
Power on all the physical partitions.
From the XSCF shell, enter the poweron command.
In this example, the poweron
command is entered for all the physical partitions and "y" is entered for the
confirmation query.
Chapter 10 Setting Up the System 369

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English