Fujitsu Oracle SPARC M12-2

A
Note -
If you are replacing only a FANU, this step is not necessary.
Note -
Before removing the FANBPU, remove all the FANUs from it.
Figure 14-2
Latch of the FANU
3.
Remove the FANU.
Hold the latch of the FANU, and pull out the FANU from the FANBPU.
Figure 14-3
Removing a FANU
14.3.2 Removing the FANBPU
This section describes the procedure for removing the FANBPU.
1.
Loosen the three fixing screws of the FANBPU.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023406