Fujitsu Oracle SPARC M12-2 User Manual

Please execute the following steps:
1) Remove BB#0/PSU#0.
2) Execute either the following:
2-1) After installing the exchanged device, please select 'finish'.
2-2) If you want to suspend the maintenance without exchanging device,
please select 'cancel'.
[f:finish|c:cancel] :
XSCF>
replacefru
------------------------------------------------------------------------------
Maintenance/Replacement Menu
Please select the chassis including replaced FRU.
No. FRU Status
--- ------------------- --------------
1 /BB#0 Normal
2 /BB#1 Normal
3 /BB#2 Unmount
4 /BB#3 Unmount
------------------------------------------------------------------------------
Select [1-4|c:cancel] :
1
------------------------------------------------------------------------------
Maintenance/Replacement Menu
Please select the BB or a type of FRU to be replaced.
1. BB itself
2. FAN (Fan Unit)
7.
Remove the PSU, as instructed in the output message.
Do not enter "f" until you mount the replacement PSU.
After mounting the replacement PSU, incorporate it into the SPARC M12-2/M12-2S
by using the procedure described in "10.4.3 Incorporating the PSU."
9.6.4 Releasing the XSCFU
This section describes the procedure for releasing the XSCFU of the SPARC M12-2S.
Note that you can replace the XSCFU using the replacefru command only in a 2BB or
larger configuration.
1.
Log in to the XSCF shell.
2.
Execute the replacefru command to display the maintenance menu.
3.
With a number key, select
the FRU requiring maintenance.
Enter "1" to perform maintenance on the XSCFU of the SPARC M12-2 (BB#0).
4.
With a number key, select the FRU requiring maintenance.
Enter "4" to perform maintenance on the XSCFU of the SPARC M12-2.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023316

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English