Fujitsu Oracle SPARC M12-2

Initial diagnosis has completed.
PSB power off sequence started. [1200sec]
0..... 30.....end
PSB powered off.
PSB Test Fault
---- ------- --------
00-0 Passed Normal
done
------------------------------------------------------------------------------
Maintenance/Replacement Menu
Status of the replaced FRU.
FRU Status
------------------- --------------
/BB#0 Normal
------------------------------------------------------------------------------
The replacement of BB#0 has completed normally.[f:finish] :
f
------------------------------------------------------------------------------
Maintenance/Replacement Menu
Please select the chassis including replaced FRU.
No. FRU Status
--- ------------------- --------------
1 /BB#0 Normal
2 /BB#1 Normal
3 /BB#2 Normal
4 /BB#3 Normal
------------------------------------------------------------------------------
Select [1-4|c:cancel] :
c
XSCF>
3.
Check the hardware diagnosis result.
Check that Normal is displayed under Status. Then, enter "f" to finish the
maintenance of the SPARC M12-2S.
If the displayed status is abnormal (Degrade or Fault), finish the maintenance of
the SPARC M12-2S and return to the maintenance start screen. Perform
maintenance on the SPARC
M12-2S again, and check whether the replaced FRU
is correctly mounted.
4.
End the replacefru command.
When the maintenance start screen appears, enter "c" to end the replacefru
command.
10.4.2 Incorporating the FANU
This section describes the procedure for incorporating the FANU into the system.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023340