Fujitsu Oracle SPARC M12-2 User Manual

lease execute the following steps:
1) Confirm the Check LED is blinking.
2) Remove BB#0/FANU#0.
3) Execute either the following:
3-1) After installing the exchanged device, please select 'finish'.
3-2) If you want to suspend the maintenance without exchanging device,
please select 'cancel'.
[f:finish|c:cancel] :
f
Waiting for BB#0/FANU#0 to enter install state.
[This operation may take up to 1 minute(s)]
(progress scale reported in seconds)
0 done
Initializing for BB#0/FANU#0 have started.
[This operation may take up to 6 minute(s) 30 second(s)]
(progress scale reported in seconds)
0 done
------------------------------------------------------------------------------
Maintenance/Replacement Menu
Status of the replaced FRU.
FRU Status
------------------- --------------
/BB#0/FANU#0 Normal
------------------------------------------------------------------------------
The replacement of BB#0/FANU#0 has completed normally.[f:finish] :
f
This procedure is done after the faulty FANU is removed, as described in "9.6.2
Releasing the FANU," and the replacement FANU is mounted.
1.
Incorporate the FANU into the system.
After mounting the replacement FANU, return to the operation screen of the
replacefru command and enter "f".
During the incorporation process,
the following screen is displayed to let you
check the status.
2.
Check the result of incorporating the FANU.
Check that Normal is displayed under Status. Then, enter "f" to finish the
maintenance of the FANU.
If the displayed status is abnormal (Degrade or Fault), finish the maintenance of
the FANU and return
to the maintenance start screen. Perform maintenance on
the FANU again, and check whether the FANU is correctly mounted.
3.
End the replacefru command.
When the maintenance start screen appears, enter "c" to end the replacefru
command.
Chapter 10 Setting Up the System 341

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English