Fujitsu Oracle SPARC M12-2

Note -
Confirm that the front cover is firmly installed and secured.
10.1.3 Installing the Front Cover
This section describes the procedure for installing the front cover on the SPARC M12.
Install the front cover before putting the SPARC M12 into operation.
1.
Insert the tabs on the front cover into the slots on the bottom front of the
chassis to install the front cover.
A label on which a
serial number is printed is affixed both at the lower front
right of the front cover and on the right side of the front of the chassis. Before
installing the front cover, check that the serial numbers match.
Figure 10-5
Installing the Front Cover
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023328