Fujitsu Oracle SPARC M12-2

Caution -
Do not perform maintenance work while OpenBoot PROM is running
(with ok prompt displayed). Perform maintenance work with the physical partition
powered off or with Oracle Solaris running.
Chapter 9
Releasing FRUs From the System
This chapter describes the procedures that you may need to perform in the XSCF
firmware or Oracle Solaris before removing FRUs from the SPARC M12-2/M12-2S.
See this chapter, as required, when performing maintenance work for each FRU
described in Chapter 11 or subsequent chapters.
■
Saving Setting Information
■
Checking the Operation Status and Resource Usage Status of Oracle Solaris
■
Releasing I/O Resources From a Logical Domain
■
Enabling the Removal of Hardware
■
Stopping the System
■
Releasing FRUs From the System
■
Removing the SPARC M12-2S
■
Accessing a FRU
9.1 Saving Setting Information
This section describes how to save logical domain configuration information and the
XSCF firmware setting information.
Be sure to save the setting information before starting system operation or after
changing the system configuration (e.g., after setting up the SPARC M12-2/M12-2S or
after changing the hardware configuration or domain configuration).
261