Fujitsu Oracle SPARC M12-2

1
2
Note -
For your safety, remove the power cord from the PSU before removing the PSU from
the server.
Note -
When inserting the PSU into the server, make sure that the PSU power outlet is on the
left side.
Figure 13-4
Removing a PSU
13.4 Installing a PSU
This section describes the procedure for installing a PSU in the server.
1.
Install a PSU in the server.
Insert the PSU into the server, push it until its latch locks, and then push up the
handle of the PSU.
Figure 13-5
Installing a PSU
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023400