Fujitsu Oracle SPARC M12-2 User Manual

------------------------------------------------------------------------------
Maintenance/Replacement Menu
Status of the replaced FRU.
FRU Status
------------------- --------------
/BB#0/PSU#0 Normal
------------------------------------------------------------------------------
The replacement of BB#0/PSU#0 has completed normally.[f:finish] :
f
------------------------------------------------------------------------------
Maintenance/Replacement Menu
Please select the chassis including replaced FRU.
No. FRU Status
--- ------------------- --------------
1 /BB#0 Normal
2 /BB#1 Unmount
3 /BB#2 Unmount
4 /BB#3 Unmount
------------------------------------------------------------------------------
Select [1-4|c:cancel] :
c
Please execute the following steps:
1) Confirm the XSCF STANDBY LED of BB#0/XSCFU is not lit.
2) Remove BB#0/XSCFU.
3) After installing the exchanged device, please select [f:finish] :
f
maintenance of the PSU.
If the displayed status is abnormal (Degrade or Fault), finish the maintenance of
the PSU and return to the maintenance start screen. Perform maintenance on the
PSU again, and check whether the PSU is correctly mounted.
3.
End the replacefru command.
When the maintenance start screen appears, enter
"c" to end the replacefru
command.
10.4.4 Incorporating the XSCFU
This section describes the procedure for incorporating the replacement XSCFU into
the SPARC M12-2S. This procedure is done after the faulty XSCFU is removed, as
described in "9.6.4 Releasing the XSCFU," and the replacement XSCFU is mounted.
1.
Incorporate the XSCFU into the system.
After mounting the replacement XSCFU, wait at
least 10 seconds. Then, return to
the operation screen of the replacefru command and enter "f".
During the incorporation process, the following screen is displayed to let you
Chapter 10 Setting Up the System 343

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English