Fujitsu Oracle SPARC M12-2 User Manual

XSCF>
testsb -v -p -s -y 01-0
Initial diagnosis is about to start, Continue?[y|n] :
y
PSB#01-0 power on sequence started.
:
(Omitted)
:
/pci@8500/pci@4/pci@0/pci@0/scsi@0
FCode Version 1.00.56, MPT Version 2.00, Firmware Version 20.00.10.00
Target a
Unit 0 Encl Serv device FUJITSU BBEXP 1303
SASAddress 500000e0e0b0117d PhyNum 14
/pci@8100/pci@4/pci@0/pci@0/scsi@0
FCode Version 1.00.56, MPT Version 2.00, Firmware Version 20.00.10.00
Target a
Unit
0 Disk TOSHIBA AL13SEB600 3703 1172123568 Blocks, 600 GB
SASDeviceName 50000396f8120578 SASAddress 50000396f812057a PhyNum 0
Target b
Unit 0 Disk TOSHIBA AL13SEB600 3703 1172123568 Blocks, 600 GB
SASDeviceName 50000396f8120498 SASAddress 50000396f812049a PhyNum 1
Target c
Unit 0 Encl Serv device FUJITSU BBEXP 1303
SASAddress 500000e0e0b0117d PhyNum 14
:
10.5.1 Diagnosing the SPARC M12 Hardware
This section describes the procedure for performing a hardware diagnosis on the
SPARC M12.
If the CMUL has been replaced, confirm that the combination of the CMUL and
XSCFU types is correct by using the showhardconf command, before performing step
(1) or (2) below. For details, see Table 8-2 in "8.1.6
Checking FRU Information."
Select either step (1) or (2) below to perform a hardware diagnosis on the SPARC
M12 with the testsb command.
(1) Diagnosing the SPARC M12 by specifying its PSB
(2) Diagnosing all the SPARC M12 units
For a configuration with only one SPARC M12-2 or SPARC M12-2S, either of
steps (1)
and (2) can be selected for the diagnosis.
<Description of options>
-v: Displays a detailed message on the hardware diagnosis.
-p: Displays the storage connected to the SPARC M12.
-s: Displays the device tree.
-a: Diagnoses all the mounted SPARC M12 units.
If you do not specify -a, you need to
specify the PSB of the SPARC M12-2S to be
diagnosed.
(1) Diagnosing the SPARC M12 by specifying its PSB
The following example runs the hardware diagnosis on the SPARC M12-2S with PSB
01-0 and checks the I/O connections.
Chapter 10 Setting Up the System 347

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English