Fujitsu Oracle SPARC M12-2 User Manual

primary#
cfgadm -c unconfigure c2::dsk/c2t50000394281B59D6d0
primary#
cfgadm -al
Ap_Id Type Receptacle Occupant Condition
(Omitted)
c2 scsi-sas connected configured unknown
c2::dsk/c2t50000394281B59D6d0
disk connected unconfigured unknown
c2::es/ses0 ESI connected configured unknown
c2::smp/expd0 smp connected configured unknown
c3 scsi-sas connected unconfigured unknown
c4 scsi-sas connected unconfigured unknown
c5 fc connected unconfigured unknown
c6 fc connected unconfigured unknown
c7 scsi-sas connected unconfigured unknown
(Omitted)
primary#
cfgadm -x led=fault,mode=blink c2::dsk/c2t50000394281B59D6d0
Note -
The precautions for PPAR DR may vary depending on the versions of the XSCF
firmware, Oracle Solaris, and Oracle VM for SPARC used and the version of the SRU
The following example assumes that the user logs in to Oracle Solaris on the
control domain and releases the HDD/SSD from the Oracle Solaris device
configuration by using the Ap_Id checked in step 3.
5.
Confirm that you can remove the HDD/SSD.
The following example assumes that the user logs in to
Oracle Solaris on the
control domain and confirms that the HDD/SSD has been released from the
Oracle Solaris device configuration.
6.
Have the CHECK LED (amber) of the HDD/SSD to be removed blink.
The following example assumes that the user logs in to Oracle Solaris on the
control domain, causing the CHECK
LED (amber) of the HDD/SSD to blink.
Check the LEDs on the HDD/SSD, and then remove it. When removing a hard
disk, pull it out slightly from its slot, wait for 10 seconds, and then remove it.
9.4.3 Dynamically Releasing the SPARC M12-2S From
the Physical Partition
PPAR DR can be used in a building block configuration connecting two or more
SPARC M12-2S units to a physical partition. By using PPAR DR, you can release the
SPARC M12-2S from the physical partition without stopping Oracle Solaris on the
logical domain.
This section describes the procedure for releasing the
SPARC M12-2S by using PPAR
DR in a building block configuration connecting two or more SPARC M12-2S units.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023294

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English