Fujitsu Oracle SPARC M12-2 User Manual

*1 Enter the login password of the HTTPS server.
Note -
When adding the SPARC M12-2S due to a change in the building block configuration,
be sure to perform the procedure described below.
Note -
To add a SPARC M12-2S with 64 GB DIMMs mounted, see "Notes on Memory" in the
latest version of the Fujitsu SPARC M12 Product Notes.
XSCF>
showboards -a -v
PSB R PPAR-ID(LSB) Assignment Pwr Conn Conf Test Fault
---- - ------------ ----------- ---- ---- ---- ------- --------
00-0 00(00) Assigned y y y Passed Normal
01-0 00(01) Assigned y y y Passed Normal
XSCF>
10.3 Adding the SPARC M12-2S to a
Building Block Configuration
This section describes the procedure for adding the SPARC M12-2S to BB#2 of the
building block configuration.
The added SPARC M12-2S is incorporated into the building block configuration in
the factory-default state. When you add a newly purchased SPARC M12-2S, do not
connect power cords until instructed so. If the SPARC
M12-2S to be added has been
used in another system, be sure to reset it to its factory-default state by using the
restoredefaults or initbb command and do not connect power cords until instructed
so.
To perform system-stopped/cold addition of the SPARC M12-2S to a building block
configuration, see "5.6.6
System-Stopped/Cold Addition Workflow of the SPARC
M12-2S."
For details on the commands used here, see the Fujitsu SPARC M12 and Fujitsu
M10/SPARC M10 XSCF Reference Manual of the XCP version used.
1.
Check the operation status of the building block configuration.
Log in to the master XSCF, and check the
operation status of the building block
configuration by using the showboards command.
The following example shows that BB#00 and BB#01 are connected to the
building block configuration.
2.
Set a BB-ID for the SPARC M12-2S.
Chapter 10 Setting Up the System 333

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English