Fujitsu Oracle SPARC M12-2

Note -
The XSCF BB control cable is used in a building block configuration consisting of
multiple SPARC M12-2S units.
Chapter 22
Maintaining the XSCF BB Control
Cable
This chapter describes the maintenance procedures for the XSCF BB control cable.
■
XSCF BB Control Port
■
Before Maintenance on the XSCF BB Control Cable
■
Removing the XSCF BB Control Cable
■
Installing the XSCF BB Control Cable
22.1 XSCF BB Control Port
The XSCF BB control cable is used in a building block configuration consisting of
multiple SPARC M12-2S units to connect the XSCFs of those SPARC M12-2S units.
Connect the XSCF BB control cable to the XSCF BB control port on the rear of the
server. Figure 22-1 shows the locations of
the XSCF BB control ports.
517