Fujitsu Oracle SPARC M12-2 User Manual

Table 4-62
System-Stopped/Cold Replacement Procedure of the BPU (continued)
Work
Order
Task Reference
5 Switching the mode switch on the OPNL
to Service
"2.3.2 OPNL Control Function"
6Removing the power cords of all the
SPARC M12-2/M12-2S units
"9.8.2 Removing the Power Cords"
7Removing the BPU from the SPARC
M12-2/M12-2S
"18.4 Removing the BPU and PSUBP"
8 Installing the BPU in the SPARC M12-2/
M12-2S
"18.5 Installing
the BPU and PSUBP"
9 Installing the power cords on all the
SPARC M12-2/M12-2S units
"10.1.1 Installing a Power Cord"
10 Diagnosing all the SPARC M12-2/M12-2S
units
"10.5.1 Diagnosing the SPARC M12
Hardware"
11 Confirming that there is no problem with
the replacement BPU
"10.5.3 Checking the FRU Status After
Maintenance"
12 Switching the mode
switch on the OPNL
to Locked
"2.3.2 OPNL Control Function"
13 Powering on the physical partitions "10.9.1 Starting the System With an
XSCF Command"
14 Checking the operating condition of the
system
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical Domains"
Table 4-63
System-Stopped/Cold Replacement Procedure of the PSUBP
Work
Order
Task Reference
1 Checking the operating condition of the
system
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical Domains"
2 Confirming the PSUBP to be replaced "8.2 Troubleshooting"
3 Checking the operation status of the
SPARC M12-2/M12-2S that houses the
PSUBP to be replaced
"8.1.2 Checking Hardware"
4 Stopping all physical partitions "9.5.2 Stopping All Physical
Partitions"
5 Switching the mode switch on the OPNL
to Service
"2.3.2 OPNL Control Function"
4.6.12 System-Stopped/Cold Replacement Workflow of
the PSUBP
Table 4-63 shows the workflow for system-stopped/cold replacement of the PSUBP.
Chapter 4 FRU Replacement Workflows 143

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English