Fujitsu Oracle SPARC M12-2 User Manual

Table 6-14
Inactive/Cold Removal Procedure of the HDD/SSD (continued)
Work
Order
Task Reference
3 Confirming that you can remove the
HDD/SSD to be removed (*1)
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical Domains"
4Saving logical domain configuration
information
"9.1.1 Saving Logical Domain
Configuration Information"
5 Powering off the physical partition
containing the SPARC M12-2S that
houses the HDD/SSD to be removed
"9.5.1 Stopping
a Specific Physical
Partition"
6 Switching the mode switch on the OPNL
to Service
"2.3.2 OPNL Control Function"
7 Releasing the SPARC M12-2S that houses
the HDD/SSD to be removed, from the
building block configuration
"9.6.1 Releasing the SPARC M12-2S
From the Building Block Configuration"
8Removing the HDD/SSD to be removed
from
the SPARC M12-2S
"15.3.1 Removing an HDD/SSD"
9
Installing a filler unit in the SPARC M12-2S "15.4.2 Installing a Filler Unit"
10 Incorporating the SPARC M12-2S from
which the HDD/SSD was removed into
the building block configuration
"10.4.1 Incorporating the SPARC
M12-2S Into a Building Block
Configuration"
11 Powering on the physical partition
containing the SPARC M12-2S that
underwent maintenance
"10.9.1 Starting the System With an
XSCF Command"
12 Confirming that there is no problem with
the system from which the HDD/SSD was
removed
"10.5.3 Checking the FRU Status After
Maintenance"
13 Switching the mode switch on the OPNL
to Locked
"2.3.2 OPNL Control Function"
14 Checking the operating condition of the
physical partition and logical domains (*1)
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical Domains"
15 Saving logical domain configuration
information
"9.1.1 Saving Logical Domain
Configuration Information"
*1 Reconfigure logical domains as required. For details, see "Chapter 3 Operations for Domain Configuration" in
the Fujitsu SPARC M12 and Fujitsu M10/SPARC M10 Domain Configuration Guide. If you have reconfigured a
logical domain, save the logical domain configuration information.
6.4.3 Inactive/Cold Removal Workflow of the CMUU
You can perform inactive/cold removal of the CMUU in the following configuration:
■
Configuration connecting two or more SPARC M12-2S units to a physical partition
Before removing the CMUU, see "Precautions for CMUU removal" in "7.3
Precautions for FRU Reduction."
Chapter 6 FRU Removal Workflows 209

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English