Fujitsu Oracle SPARC M12-2 User Manual

------------------------------------------------------------------------------
Maintenance/Replacement Menu
Please select the chassis including replaced FRU.
No. FRU Status
--- ------------------- --------------
1 /BB#0 Normal
2 /BB#1 Unmount
3 /BB#2 Unmount
4 /BB#3 Unmount
------------------------------------------------------------------------------
Select [1-4|c:cancel] :
c
Please execute the following steps:
1) Remove BB#0/PSU#0.
2) Execute either the following:
2-1) After installing the exchanged device, please select 'finish'.
2-2) If you want to suspend the maintenance without exchanging device,
please select 'cancel'.
[f:finish|c:cancel] :
f
Waiting for BB#0/PSU#0 to enter install state.
[This operation may take up to 1 minute(s)]
(progress scale reported in seconds)
0 done
Diagnostic tests for BB#0/PSU#0 have started.
[This operation may take up to 2 minute(s)]
(progress scale reported in seconds)
0..... 30.... done
10.4.3 Incorporating the PSU
This section describes the procedure for incorporating the replacement PSU into the
system. This procedure is done after the faulty PSU is removed, as described in "9.6.3
Releasing the PSU," and the replacement PSU is mounted.
1.
Incorporate the PSU into the system.
Mount the replacement PSU, and connect the power
cord to it. After connecting
the power cord, wait for at least 10 seconds. Then, return to the operation screen
of the replacefru command and enter "f".
During the incorporation process, the following screen is displayed to let you
check the status.
2.
Check the result of incorporating the PSU.
Check that Normal
is displayed under Status. Then, enter "f" to finish the
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023342

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English