Fujitsu Oracle SPARC M12-2 User Manual

XSCF>
showstatus
XSCF>
XSCF>
showhardconf
#
svcs hotplug
←
If the STATE is disabled, enable the service.
#
svcadm enable hotplug
←
Enables the hotplug service.
Note -
To perform maintenance on a PCIe card by using the hot plug function, see "Appendix
B Cards That Support PCI Hot Plug and Dynamic Reconfiguration" in the Fujitsu SPARC
M
12 PCI Card Installation Guide to check whether the card can use PCI Hot Plug.
6.
Check the hardware configuration.
Enter the showhardconf command to check that the replacement FRU has been
incorporated into the system. If there is an error, an asterisk (*) appears at the
beginning of the line on which the corresponding FRU name is shown.
Hereinafter, perform the procedure described in "10.7 Incorporating
I/O Resources
Into a Logical Domain" to assign I/O resources to logical domains.
If you have replaced a FRU with the SPARC M12-2S released from the building block
configuration, return the I/O configuration of the logical domains to the state it was
in before maintenance.
If you have added the SPARC
M12-2S to the building block configuration, assign the
CPU resources, memory resources, and I/O resources as appropriate for the system
configuration of the logical domains.
10.6.2 Incorporating an I/O Device Into the Physical
Partition by Using the Hot Plug Function
This section describes the flow of the procedure for incorporating an I/O device by
using the hot plug function.
To use the hot plug function, the hotplug service of Oracle Solaris must be enabled.
Check the status of the hotplug service. If it is disabled, perform the following step to
enable
the service. You can use the hot plug function only on the control domain and
root domain.
For details on cfgadm used here, see "Dynamically Configuring Devices" in the
Managing Devices in Oracle Solaris for the Oracle Solaris version used.
When incorporating a PCIe card
Install a PCIe card in the target PCI slot, and perform the following procedure to
incorporate it into a logical domain.
1.
Log in to Oracle Solaris.
Chapter 10 Setting Up the System 357

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English