Fujitsu Oracle SPARC M12-2 User Manual

#
cfgadm -x led=attn,mode=blink BB#0-PCI#0
(*1)
#
*1 The ATTENTION LED on BB#0-PCI#0 is blinking.
#
cfgadm -a
Ap_Id Type Receptacle Occupant Condition
BB#0-PCI#0 unknown disconnected unconfigured unknown
#
cfgadm -c connect BB#0-PCI#0
#
#
cfgadm -c configure BB#0-PCI#0
#
Log in to the logical domain (control domain or root domain) into which the
target PCIe card will be incorporated.
The following steps are not necessary when you are replacing the PCIe card.
When adding a PCIe card, see the following example of the command executed
to blink the ATTENTION LED of
the PCI slot into which the PCIe card will be
mounted.
2.
Mount the PCIe card in the SPARC M12-2/M12-2S.
Mount the PCIe card in the SPARC M12-2/M12-2S by using the procedure
described in "Chapter 12 Maintaining PCIe Cards."
3.
From Oracle Solaris, check the mounting status of the PCIe card.
The
following example checks that the PCIe card is mounted in BB#0-PCI#0.
4.
Supply power to the mounted PCIe card.
The following example executes the cfgadm command with the connect option
in Oracle Solaris on the control domain or root domain, to start power supply to
the PCIe card mounted in BB#0-PCI#0.
5.
Incorporate
the PCIe card into the logical domain.
The following example executes the cfgadm command with the configure option
in Oracle Solaris on the control domain or root domain, to incorporate the PCIe
card mounted in BB#0-PCI#0 into the Oracle Solaris device configuration.
6.
Confirm that the PCIe card has been incorporated into the device configuration.
The following example executes the cfgadm command with the -a option in
Oracle Solaris on the control domain or root domain, to confirm that the PCIe
card mounted in BB#0-PCI#0 has been incorporated into the Oracle Solaris
device configuration.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023358

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English