Fujitsu Oracle SPARC M12-2 User Manual

XSCF>
showpparprogress -p 0
PPAR Power Off PPAR#0 [ 1/ 3]
CPU Stop PPAR#0 [ 2/ 3]
PSU Off PPAR#0 [ 3/ 3]
The sequence of power control is completed
XSCF>
XSCF>
showpparstatus -a
PPAR-ID PPAR Status
00 Powered Off
01 Running
02 Running
03 Running
XSCF>
Table 9-13
Procedure for Stopping All Physical Partitions by Using the XSCF Commands
Step Operation Description Command Used
1 Checking the operation status of
physical partitions
XSCF> showpparstatus -a
As required, checking the operation
status of the logical domains on the
physical partitions
XSCF> showdomainstatus -p <ppar_id>
2 Checking the status of each SPARC
M12-2S
XSCF> showboards -a
3 Stopping all physical partitions XSCF> poweroff -a
As required, checking the stop
processing status of the
physical
partitions
XSCF> showpparprogress -p <ppar_id>
4 Confirming that all physical partitions
have stopped
XSCF> showpparstatus -a
5.
Confirm that the target physical partition has stopped.
The following example checks that only PPAR-ID#00 is stopped while the other
physical partitions are running.
9.5.2 Stopping All Physical Partitions
This section describes the procedure for stopping all physical partitions.
You can stop all physical partitions by using either the XSCF commands or the
OPNL.
Stopping all physical partitions from the XSCF shell
Log in to the master XSCF, and stop all physical partitions by following the
procedure in Table 9-13.
Chapter 9 Releasing FRUs From the System 307

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English