Fujitsu Oracle SPARC M12-2 User Manual

Note -
If you are replacing an HDD/SSD, this step is not necessary.
Figure 15-4
Removing the Filler Unit
15.4 Installing an HDD/SSD or Filler Unit
This section describes the procedure for installing an HDD/SSD or an HDD/SSD filler
unit. To add an HDD/SSD, use the same procedure.
15.4.1 Installing an HDD/SSD
1.
Remove a filler unit.
To add an HDD/SSD, remove the filler unit mounted in the HDDBPU in which
to install the HDD/SSD. For the removal procedure, see "15.3.2 Removing a
Filler Unit."
2.
Insert the HDD/SSD into the HDDBPU.
Install the HDD/SSD in the HDDBPU, with the removal lever open.
Chapter 15 Maintaining Internal Storage 417

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English