Fujitsu Oracle SPARC M12-2 User Manual

XSCF>
showhardconf
SPARC M12-2S;
+ Serial:2081232002; Operator_Panel_Switch:Service
;
+ System_Power:On; System_Phase:Cabinet Power On;
Partition#0 PPAR_Status:Running;
(Omitted)
XSCF>
showlogs event
May 30 14:00:13 JST 2016 power switch pushed (short)
May 30 14:01:13 JST 2016 power switch pushed (long)
May 30 14:01:16 JST 2016 PPAR-ID 0:shutdown started
(Omitted)
XSCF>
showpparstatus -a
PPAR-ID PPAR Status
00 Powered Off
01 Powered Off
02 Powered Off
03 Powered Off
XSCF>
4.
Press down the POWER switch on the OPNL for 4 seconds or longer.
For details on the POWER switch, see "2.3.2 OPNL Control Function."
5.
Confirm the instruction to stop the physical partitions.
If you do not push down the POWER switch long enough, the message "power
switch pushed (short)" appears.
If so, try again to press down the POWER switch
for 4 seconds or longer.
6.
Confirm that all physical partitions have stopped.
9.6 Releasing FRUs From the System
This section describes the procedure for releasing a FRU from the system.
■
Releasing the SPARC M12-2S From the Building Block Configuration
■
Releasing the FANU
■
Releasing the PSU
■
Releasing the XSCFU
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023310

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English