Fujitsu Oracle SPARC M12-2 User Manual

Note -
The hot replacement of the XSCFU is possible only in a building block configuration
connecting multiple SPARC M12-2S units. When maintaining the XSCFU in a configuration
using only one SPARC M12-2 or SPARC M12-2S, remove the power cord and perform
system-stopped/cold replacement.
Chapter 11
Maintaining the XSCF Unit
This section describes the maintenance procedures for the XSCFU mounted in the
SPARC M12-2/M12-2S.
■
Maintenance Precautions
■
Location of the XSCFU
■
Before Maintenance on the XSCFU
■
Removing the XSCFU
■
Switching an SD Card
■
Installing the XSCFU
11.1 Maintenance Precautions
Note the following points when you maintain the XSCFU.
■
Do not replace the XSCFU and the PSUBP at the same time. If the XSCFU and the
PSUBP are replaced at the same time, the system may fail to operate normally.
■
Do not mount and use any of the following SD cards in the XSCFU in another
chassis:
- the one currently mounted in the SPARC M12-2/M12-2S, or
- one that was once used as a maintenance part
This is because these SD cards store device identification information.
■
If you replace the SD card along with the XSCFU, dispose of the SD card mounted
on the old XSCFU by appropriate means such as cutting it with cutting pliers.
The old SD card stores the user information, IP address, and other information set
373

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English