Fujitsu Oracle SPARC M12-2 User Manual

Table 4-43
Inactive/Cold Replacement Procedure of a PCI Expansion Unit (continued)
Work
Order
Task Reference
5 Switching the mode switch on the OPNL
to Service
"2.3.2 OPNL Control Function"
6 Releasing the SPARC M12-2S requiring
maintenance from the building block
configuration
"9.6.1 Releasing the SPARC M12-2S
From the Building Block Configuration"
7Removing the FRUs in the faulty PCI
expansion unit
PCI Expansion Unit for Fujitsu SPARC
M12 and
Fujitsu M10/SPARC M10 Service
Manual
8
Installing a FRU in the PCI expansion unit PCI Expansion Unit for Fujitsu SPARC
M12 and Fujitsu M10/SPARC M10 Service
Manual
9 Incorporating the SPARC M12-2S that
required maintenance into the building
block configuration
"10.4.1 Incorporating the SPARC
M12-2S Into a Building Block
Configuration"
10 Diagnosing the SPARC M12-2S requiring
maintenance
"10.5.1 Diagnosing the SPARC M12
Hardware"
11 Powering on the physical
partition
containing the SPARC M12-2S that
underwent maintenance
"10.8 Powering on a Physical Partition"
(*1)
12 Confirming that there is no problem with
the replacement PCI expansion unit
"10.5.3 Checking the FRU Status After
Maintenance"
13 Switching the mode switch on the OPNL
to Locked
"2.3.2 OPNL Control Function"
14 Checking the operating condition
of the
system
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical Domains"
*1 Do not switch the mode switch on the OPNL to Locked at this point.
4.4.16 Inactive/Cold Replacement Workflow of the XSCF
DUAL Control Cable
You can perform inactive/cold replacement of the XSCF DUAL control cable in the
following configuration:
■
Building block configuration where two or more physical partitions are operating
Table 4-44 shows the workflow for inactive/cold replacement of the XSCF DUAL
control cable.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023122

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English