Fujitsu Oracle SPARC M12-2 User Manual

Table 3-5
Applicable Types of Maintenance in FRU Replacement for the SPARC M12-2
-: Not applicable
FRU Active Replacement Inactive Replacement System-Stopped
Replacement
Hot Cold Hot Cold Hot Cold
XSCFU - ---- OK
PCIe card OK (*1)---OKOK
PSU OK (*2)---OKOK
FANU OK (*2)---OKOK
FANBPU - - - - - OK
HDD/SSD OK (*3)---OKOK
HDDBPU - - - - - OK
OPNL - - - - - OK
CMU - ---- OK
Memory - - - - - OK
BPU - ---- OK
PSUBP - ---- OK
PCI expansion unit (chassis) OK - - - OK OK
*1 Maintenance is performed using the SR-IOV function, dynamic reconfiguration function for PCIe devices, and
PCI Hot Plug function.
*2 This is possible only if the target FRU is in a redundant configuration.
*3 This is possible only for the mirror volumes (RAID1 and RAID1E) when the HDD/SSD used as the boot
device
is being replaced.
3.2 Types of Maintenance Applicable to
the SPARC M12-2
This section describes the types of maintenance applicable to each FRU of the SPARC
M12-2, according to the particular purpose of maintenance.
Inactive maintenance is not available for the SPARC M12-2. Inactive maintenance is
possible only in systems that use the SPARC M12-2S in a building block configuration.
3.2.1 Types of Maintenance for FRU Replacement
(SPARC M12-2)
Table 3-5 lists the replaceable FRUs in the SPARC M12-2 and the applicable types of
maintenance in the replacement of each FRU.
Chapter 3 Understanding the Types of Maintenance 43

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English