Fujitsu Oracle SPARC M12-2

Caution -
In an emergency (such as smoke or flames coming from the SPARC M12-2/
M12-2S), immediately stop using the unit and turn off the power supply. Give top
priority to fire prevention, even if the system is in operation.
1.7 Emergency Power-Off
This section describes the procedure for powering off the system in an emergency.
After removing the cable clamps from the power cords, remove the power cords
from the power supply unit.
1.
Release the tab of the cable clamp (A in Figure 1-6).
Figure 1-6
Releasing a Cable Clamp
2.
Remove the power
cords from all the power supply units.
Chapter 1 Before Starting Maintenance Work 9