Fujitsu Oracle SPARC M12-2

Caution -
Pulling out the CMUL with these cables (LAN, SAS, USB, or other cables)
connected may damage the connectors.
17.4 Removing the CMU or Memory
This section describes the procedure for removing the CMU or memory.
17.4.1 Enabling the Removal of the CMU
To enable the removal of the CMU, you need to remove the FANBPU, HDDBPU,
PCIe cards, and XBU from the server. This section describes the procedure for
removing the other units from the server before removing the CMU.
1.
Place the server in the cold state.
For details on handling power cords,
see "9.8.2 Removing the Power Cords."
2.
Lower the cable support.
For details on handling the cable support, see "9.8.1 Lowering the Cable
Support."
3.
The CMUL may have a LAN cable, SAS cable, USB cable, or other cable
connected to it. Remove them all.
4.
Pull out the PCIe card from
the server.
For details on handling the PCIe card, see "12.3.1 Enabling the Removal of a
PCIe Card."
Chapter 17 Maintaining the CPU Memory Unit and Memory 439