Fujitsu Oracle SPARC M12-2 - C.2 Removing the Lithium Battery

Location No. Component
1 Lithium battery
C.2 Removing the Lithium Battery
This section describes the procedure for removing the lithium battery.
1.
Insert a flathead screwdriver or another fine-tipped tool between the lithium
battery and battery holder, and pry the battery from the holder.
Figure C-2
Removing the Lithium Battery (1)
2.
Gripping the lithium battery at the top with needle-nose pliers or
another
fine-tipped tool, pull up the lithium battery to remove it.
Figure C-3
Removing the Lithium Battery (2)
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023534