Fujitsu Oracle SPARC M12-2 User Manual

Table 4-37
Inactive/Cold Replacement Procedure of the CMU (continued)
Work
Order
Task Reference
13 Switching the mode switch on the OPNL
to Locked, and powering on the physical
partition containing the SPARC M12-2S
that has undergone maintenance
"10.8 Powering on a Physical Partition"
14 Checking the operating condition of the
system
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical Domains"
*1 If you replaced a CMU that uses the hardware RAID function, enable the hardware RAID function before
starting Oracle Solaris.
*2 If the replaced CMUU was in a SPARC M12-2S with no PCIe cards mounted, or if the CMUL was replaced, no
diagnosis is necessary (because diagnosis was performed in the
previous step).
Table 4-38
Inactive/Cold Replacement Procedure of Memory
Work
Order
Task Reference
1 Checking the operating condition of the
system
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical Domains"
2 Confirming the memory to be replaced "8.2 Troubleshooting"
3 Checking the operation status of the
SPARC M12-2S that houses the memory
to be replaced
"2.2.2 Checking Memory Information"
4 Powering off the physical partition
containing
the SPARC M12-2S that
houses the memory requiring maintenance
"9.5.1 Stopping a Specific Physical
Partition"
5 Switching the mode switch on the OPNL
to Service
"2.3.2 OPNL Control Function"
6 Releasing the SPARC M12-2S requiring
maintenance from the building block
configuration
"9.6.1 Releasing the SPARC M12-2S
From the Building Block Configuration"
7Placing the SPARC M12-2S requiring
maintenance into the cold state,
and
remo ving memory from the SPARC M12-2S
"17.4 Removing the CMU or Memory"
4.4.10 Inactive/Cold Replacement Workflow of Memory
You can perform inactive/cold replacement of memory in the following configuration:
■
Building block configuration where two or more physical partitions are operating
Before replacing the memory, see "Precautions for CMU and memory replacement"
in "7.1 Precautions for FRU Replacement."
Table 4-38 shows the workflow for inactive/cold replacement of memory.
Chapter 4 FRU Replacement Workflows 115

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English