Fujitsu Oracle SPARC M12-2 User Manual

Table 4-9
Active/Cold Replacement Procedure of a PCIe Card (continued)
Work
Order
Task Reference
8Removing the faulty PCIe card from the
SPARC M12-2S
"12.3.1 Enabling the Removal of a PCIe
Card"
9Removing the faulty PCIe card from the
PCICS
"12.3.2 Removing a PCIe Card or PCIe
Card Filler"
10 Installing the replacement PCIe card in
the PCICS to install it in the SPARC
M12-2S or PCI
expansion unit
"12.4.1 Installing a PCIe Card or PCIe
Card Filler"
11 Placing the SPARC M12-2S that required
maintenance into the hot state
"10.1.1 Installing a Power Cord"
12 Incorporating the SPARC M12-2S that
required maintenance into the building
block configuration
"10.4.1 Incorporating the SPARC
M12-2S Into a Building Block
Configuration"
13 Diagnosing
the SPARC M12-2S requiring
maintenance
"10.5.1 Diagnosing the SPARC M12
Hardware"
14 Confirming that there is no problem with
the replacement PCIe card
"10.5.3 Checking the FRU Status After
Maintenance"
15 Incorporating the SPARC M12-2S that
required maintenance into the physical
partition
"10.6.1 Incorporating the SPARC
M12-2S Into the Physical Partition Using
PPAR
DR"
16 Incorporating I/O resources of the SPARC
M12-2S requiring maintenance into a
logical domain
"10.7 Incorporating I/O Resources Into a
Logical Domain"
17 Checking the operating condition of the
system and the I/O device usage status
"9.2 Checking the Operation Status and
Resource Usage Status of Oracle Solaris"
4.2.3 Active/Cold Replacement Workflow of the PSU
You can perform active/cold replacement of the PSU in the following configuration:
■
Configuration connecting two or more SPARC M12-2S units to a physical partition
Before replacing the PSU, see "Precautions for PSU replacement" in "7.1 Precautions
for FRU Replacement."
Table 4-10 shows the workflow for active/cold replacement of the PSU.
Chapter 4 FRU Replacement Workflows 79

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English