Fujitsu Oracle SPARC M12-2 User Manual

Note -
This procedure assumes that the cables are connected to the SPARC M12-2S that has
undergone maintenance and that the READY LED on the XSCFU is blinking.
Please execute the following steps:
1) Confirm the XSCF STANDBY LED of BB#0 is not lit.
2) Turn off the breaker of BB#0.
3) Remove BB#0.
4) Execute either the following:
4-1) After the exchanged device is connected with the system,
turn on the breaker of BB#0, and please select 'finish'.
4-2) If
you want to suspend the maintenance without exchanging device,
please select 'cancel'.
[f:finish|c:cancel] :
f
Waiting for BB#0 to enter install state.
[This operation may take up to 20 minute(s)]
(progress scale reported in seconds)
0..... 30..... 60..... 90..... 120..... 150..... 180..... 210.....
240..... 270..... 300..... 330..... 360..... done
Waiting for BB#0 to enter ready state.
10.4 Incorporating a FRU Into the System
This section describes the following procedures:
■
Incorporating the SPARC M12-2S Into a Building Block Configuration
■
Incorporating the FANU
■
Incorporating the PSU
■
Incorporating the XSCFU
10.4.1 Incorporating the SPARC M12-2S Into a Building
Block Configuration
This section describes the procedure for incorporating the SPARC M12-2S that has
undergone maintenance into a building block configuration. This procedure is done
after the one described in "9.6.1 Releasing the SPARC M12-2S From the Building
Block Configuration."
1.
Incorporate the SPARC M12-2S.
Return to the operation screen of the replacefru
command of the XSCF shell, and
enter "f".
The following screen appears when you enter "f". Wait for the processing to
finish.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023338

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English