Fujitsu Oracle SPARC M12-2 User Manual

XSCF>
showlogs error
Date: Jan 30 07:25:35 UTC 2016
Code: 40000000-00b8ff0000ff0000ff-01a100210000000000000000
Status: Warning Occurred: Jan 30 07:25:31.377 UTC 2016
FRU: /BB#00/SCF_DUAL
Msg: Board control error (MBC link error)
21.2 Before Maintenance on the XSCF
DUAL Control Cable
When replacing the XSCF DUAL control cable, perform the maintenance procedure
listed below.
- 4.2.14 Active/Cold Replacement Workflow of the XSCF DUAL Control Cable
- 4.4.16 Inactive/Cold Replacement Workflow of the XSCF DUAL Control Cable
- 4.6.15 System-Stopped/Cold Replacement Workflow of the XSCF DUAL Control
Cable
Note that a system that uses
one SPARC M12-2S may be in a building block
configuration connected with another SPARC M12-2S. If so, be sure to connect the
SPARC M12-2S that houses the master XSCF to the SPARC M12-2S that houses the
standby XSCF by using the XSCF DUAL control cable.
21.3 Removing the XSCF DUAL Control
Cable
This section describes the procedure for removing the XSCF DUAL control cable.
1.
Make a note of the XSCF DUAL control cable to be replaced.
Log in to the XSCF and execute the showstatus command or showlogs error
command. Then, make a note of the ports connected to the XSCF DUAL control
cable to be replaced. For details on the commands, see "8.2.2 Identifying a
Fault."
The underlined part in the error example below indicates that an error has been
found in the XSCF DUAL control cable connected to BB#00 and BB#01.
From the above error message and "Appendix A Lists of
Cable Connections in
a Building Block Configuration," identify the port number at the other end of the
connection of the target XSCF DUAL control cable.
In this example, "BB01-DUAL" is the port number at the other end.
Chapter 21 Maintaining the XSCF DUAL Control Cable 511

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English