Fujitsu Oracle SPARC M12-2

VCONS
NAME SERVICE PORT LOGGING
guest primary-vcc0@primary 5000 on
#
primary#
ldm remove-vsw primary-vsw0
primary#
ldm remove-vdsdev vdisk00@primary-vds0
primary#
ldm rmove-vds primary-vds0
primary guest
Virtual function
/BB1/CMUL/NET0/IOVNET.PF0
/BB1/CMUL/NE
T0/IOVNET.PF0
.VF0
/BB1/CMUL/NET0/IOVNET.PF1
/BB1/CMUL/NE
T0/IOVNET.PF0
.VF0
/BB0/CMUL/NE
T0/IOVNET.PF0
.VF0
On-board LAN
4.
When removing a PCIe card assigned to virtual services using the PCI Hot
Plug function, remove all virtual services that use the PCIe card.
9.3.2 Dynamically Releasing the SR-IOV Virtual
Function From a Logical Domain
The operation of dynamically releasing the SR-IOV virtual function from a logical
domain must be performed from the control domain by executing the ldm command.
Before removing the SR-IOV virtual function, confirm that it is not being used by the
logical domain. For details, see "3.2.19 Creating or Destroying the SR-IOV
Virtual
Function" the Fujitsu SPARC M12 and Fujitsu M10/SPARC M10 Domain Configuration
Guide.
Figure 9-2
Releasing the Assignment of the SR-IOV Virtual Function
Table 9-3 lists the procedure for dynamically releasing the SR-IOV virtual function.
Chapter 9 Releasing FRUs From the System 275