Fujitsu Oracle SPARC M12-2 User Manual

Note -
If it is difficult to install the front cover, insert the left tab of the front cover into the
slot first (1 in Figure 10-6), and then insert the right tab (2 in Figure 10-6) to install the front
cover.
1
2
Figure 10-6
Installing the Front Cover (Note)
10.2 Restoring Setting Information
10.2.1 Restoring the Logical Domain System
Configuration
You can restore the logical domain system configuration from the configuration
information saved in the XSCF firmware or an XML file.
This section describes how to restore the logical domain system configuration.
For details, see "10.11 Saving/Restoring Logical Domain Configuration Information
in the XSCF" or "10.12 Saving/Restoring Logical Domain Configuration Information
in an XML File" in the Fujitsu SPARC M12 and Fujitsu M10/SPARC M10 System
Operation and Administration Guide.
Restoring the configuration from the XSCF firmware
This section describes an example of the operation of logging in to the XSCF shell,
with the physical partition (PPAR-ID#00) stopped, and restoring the logical domain
configuration from the factory-default state to the state of "ldom-config1".
If the physical partition is in operation, the system configuration is applied after the
physical
partition is stopped.
Chapter 10 Setting Up the System 329

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English