Fujitsu Oracle SPARC M12-2 User Manual

Table 4-12
Active/Cold Replacement Procedure of the FANBPU (continued)
Work
Order
Task Reference
6 Releasing the SPARC M12-2S requiring
maintenance from the building block
configuration
"9.6.1 Releasing the SPARC M12-2S
From the Building Block Configuration"
7Placing the SPARC M12-2S requiring
maintenance into the cold state, and
removing the FANBPU from the SPARC
M12-2S
"9.8.2 Removing the Power Cords"
"14.3 Removing a FANU or the
FANBPU"
8 Installing the FANBPU in the SPARC
M12-2S, and placing the SPARC M12-2S
that required maintenance into the hot
state
"14.4 Installing a FANU or the FANBPU"
9 Incorporating the SPARC M12-2S that
required maintenance into the building
block configuration
"10.4.1 Incorporating the SPARC
M12-2S Into a Building Block
Configuration"
10 Confirming that there is no problem with
the replacement FANBPU
"10.5.3 Checking the FRU Status After
Maintenance"
11 Incorporating the SPARC M12-2S that
required maintenance into the physical
partition
"10.6.1
Incorporating the SPARC
M12-2S Into the Physical Partition Using
PPAR DR"
12 Incorporating I/O resources of the SPARC
M12-2S requiring maintenance into a
logical domain
"10.7 Incorporating I/O Resources Into a
Logical Domain"
13 Checking the operating condition of the
system and the I/O device usage status
"9.2 Checking the Operation Status
and
Resource Usage Status of Oracle Solaris"
4.2.6 Active/Cold Replacement Workflow of the
HDD/SSD
You can perform active/cold replacement of the HDD/SSD in the following
configuration:
■
Configuration connecting two or more SPARC M12-2S units to a physical partition
Before replacing the HDD/SSD, see "Precautions for HDD/SSD replacement" in "7.1
Precautions for FRU Replacement."
Table 4-13 shows the workflow for active/cold replacement of the HDD/SSD.
Chapter 4 FRU Replacement Workflows 83

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English