Fujitsu Oracle SPARC M12-2 User Manual

Table 9-14
Procedure for Stopping All Physical Partitions With the OPNL
Step Operation Description Command Used
1 Checking the operation status of
physical partitions
XSCF> showpparstatus -a
Checking the operation status of a
specific physical partition or the
operation status of the logical domains
on a physical partition, as required
[Checking the operation status of a
specific physical partition]
XSCF> showpparstatus -p <ppar_id>
[Checking the operation status of logical
domains]
XSCF> showdomainstatus -p <ppar_id>
2 Checking the status of each SPARC
M12-2S
XSCF> showboards -a
3 Switching the mode switch on the OPNL
to Service mode
4 Pressing down the POWER switch on
the OPNL for 4 seconds or longer
5 Confirming the power-off instruction XSCF> showlogs event
6 Confirming that all physical partitions
have stopped
XSCF> showpparstatus -a
XSCF>
showpparstatus -a
PPAR-ID PPAR Status
00 Running
01 Running
(Omitted)
XSCF>
showboards -a
PSB PPAR-ID(LSB) Assignment Pwr Conn Conf Test Fault
---- ------------ ----------- ---- ---- ---- ------- --------
00-0 00(00) Assigned y y y Passed Normal
01-0 01(01) Assigned y y y Passed Normal
(Omitted)
The following describes the procedure for stopping all physical partitions with the
OPNL.
1.
Check the operation status of all physical partitions.
2.
Check the status of each SPARC M12-2S.
3.
Switch the mode switch on the OPNL to Service mode.
For details on the mode switch, see "2.3.2 OPNL Control Function."
You can
log in to the XSCF and check the status of the mode switch using the
showhardconf command.
Chapter 9 Releasing FRUs From the System 309

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English