Fujitsu Oracle SPARC M12-2 User Manual

Restoring primary succeeded, 163208757248 byte memory were assigned
DR sequence finished (sequence#=5, message#=6)
end
Configured PSB to Logical Domains (LDoms) Manager.
Operation has completed.
Note -
During the maintenance using PPAR DR, you cannot restore CPU socket constraints
even if you execute the addboard command with bind=resource specified in the operation
mode option (-m option). Set the constraints again using the ldm command. For details on
CPU socket constraints, see "8.14 Managing Logical Domain Resources Associated
with
CPU Sockets" in the Fujitsu SPARC M12 and Fujitsu M10/SPARC M10 System Operation and
Administration Guide and the Oracle VM Server for SPARC Reference Manual of the version
used. If resource assignments other than the CPU constraints cannot be restored, use the ldm
command as well to set them again.
XSCF>
showresult
0
Note -
For information on the action to take if the addboard command ends abnormally, see
"Appendix C Meanings of Messages and Corresponding Corrective Action" in the Fujitsu
SPARC M12 and Fujitsu M10/SPARC M10 Domain Configuration Guide.
XSCF>
showboards -a
PSB PPAR-ID(LSB) Assignment Pwr Conn Conf Test Fault
---- ------------ ----------- ---- ---- ---- ------- --------
00-0 00(00)
Assigned y y y Passed Normal
01-0 00(01) Assigned y y y Passed Normal
02-0 00(02) Assigned y y y Passed Normal
03-0 00(03) Assigned y y y Passed Normal
3.
Execute the showresult command to check the end status of the previously
executed addboard command.
If the end code is not 0, the addboard command ended abnormally. Eliminate
the cause of the failure, and then execute the addboard command again.
In the following example, "0" is returned as the end status,
so you can see that
the execution of the addboard command has completed correctly.
4.
Check the PSB configuration of the physical partition.
The following example executes the showboards command to check that
PSB#00-0 (BB#00) has been added to PPAR-ID#00 and is running normally.
5.
Check the hardware status.
The following execution example
checks the result output by the showstatus
command. If the hardware is normal, the command displays nothing.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023356

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English