Fujitsu Oracle SPARC M12-2 User Manual

XSCF>
initbb -b 2
You are about to initialize BB/XB-Box.
NOTE the following.
1. BB/XB-Box is exclueded from the system and halted.
2. PPAR-ID of the same value as BB-ID becomes invalid.
Continue? [y|n] :
y
XSCF>
XSCF>
showboards -a -v
PSB R PPAR-ID(LSB) Assignment Pwr Conn Conf Test Fault
---- - ------------ ----------- ---- ---- ---- ------- --------
00-0 00(00) Assigned y y y Passed Normal
01-0 00(01) Assigned y y y Passed Normal
XSCF>
Crossbar cable
Power cord
XSCF DUAL
control cable
XSCF BB
control cable
4.
Release the SPARC M12-2S from the building block configuration.
5.
Check that the LEDs of the released SPARC M12-2S are off.
Wait for the READY, CHECK, and MASTER LEDs on the XSCFU to turn off.
(Approx. 10 minutes)
For the LEDs on the XSCFU, see "Figure 2-11."
6.
Check the status of
the building block configuration.
Check that the released SPARC M12-2S is not displayed.
7.
Disconnect the power cord, crossbar cable, XSCF BB control cable, and XSCF
DUAL control cable.
Disconnect all the cables connected to the locations enclosed in dotted lines.
Note that, when the XSCFU is the slave XSCF, the XSCF DUAL
control cable is
not connected.
Figure 9-5
Disconnecting Cables
8.
Set the BB-ID of the released SPARC M12-2S.
To release the SPARC M12-2S and use it as another system, set the BB-ID as
appropriate for the system configuration.
Chapter 9 Releasing FRUs From the System 319

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English