Fujitsu Oracle SPARC M12-2 User Manual

Table 9-1
I/O Resources Released From Logical Domains
I/O Resource
Not Necessary to Restart Oracle Solaris
or Stop the Domain
Necessary to Restart Oracle Solaris and
Stop the Domain
Virtual I/O "9.3.1 Dynamically Releasing
Virtual I/O From a Logical
Domain"
-
SR-IOV virtual
function
"9.3.2 Dynamically Releasing
the SR-IOV Virtual Function
From a Logical Domain"
"9.3.5 Statically Releasing the
SR-IOV Virtual Function From a
Logical Domain"
PCIe endpoint "9.3.3 Dynamically Releasing
the PCIe Endpoint From a Logical
Domain"
"9.3.6 Statically Releasing
the
PCIe Endpoint From a Logical
Domain"
Root complex "9.3.4 Dynamically Releasing
the Root Complex From a Logical
Domain"
"9.3.7 Statically Releasing the
Root Complex From a Logical
Domain"
#
svcs svc:/system/hotplug:default
STATE STIME FMRI
disable 16:26:10 svc:/system/hotplug:default
#
svcadm enable svc:/system/hotplug:default
#
svcs svc:/system/hotplug:default
STATE STIME FMRI
online 16:26:10 svc:/system/hotplug:default
Note -
To perform active maintenance on a FANU, a PSU, or the XSCF unit, the work
described in this section is not required.
For details on the commands used here, see "3.2 Operations and Commands
Related to Logical Domain Configurations" in the Fujitsu SPARC M12 and Fujitsu
M10/SPARC M10 Domain Configuration Guide and the manual for the software being
used.
If the hotplug service of Oracle Solaris is disabled, enable it by following the
procedure below, and then release the I/O resources.
1.
Check the status of the hotplug service.
2.
Enable the hotplug service.
3.
Confirm that the hotplug service is enabled.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023272

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English