Fujitsu Oracle SPARC M12-2 User Manual

------------------------------------------------------------------------------
Maintenance/Replacement Menu
Please select the BB or a type of FRU to be replaced.
1. BB itself (*1)
2. FAN (Fan Unit)
3. PSU (Power Supply Unit)
4. XSCFU (Extended System Control Facility Unit)
5. Crossbar cable
------------------------------------------------------------------------------
Select [1-5|c:cancel] :
1
*1 This cannot be done with the SPARC M12-2.
------------------------------------------------------------------------------
Maintenance/Replacement Menu
Please select a FRU to be replaced.
No. FRU Status
--- ------------------- --------------
1 /BB#0 Degraded
------------------------------------------------------------------------------
Select [1|b:back] :
1
You are about to replace BB#0.
Do you want to continue?[r:replace|c:cancel] :
r
Please execute the following steps:
1) Confirm the XSCF STANDBY LED of BB#0 is not lit.
2) Turn off the breaker of BB#0.
3) Remove BB#0.
4) Execute either the following:
4-1) After the exchanged device is connected with the system,
turn on the breaker of BB#0, and please select 'finish'.
4-2) If
you want to suspend the maintenance without exchanging device,
please select 'cancel'.
[f:finish|c:cancel] :
5.
With a number key, select the faulty FRU.
6.
Confirm that the FRU requiring maintenance is displayed, and then enter "r".
7.
Confirm that the CHECK LED of the FRU is on or blinking.
To release the SPARC M12-2S, confirm that the system locator is blinking.
For the LED location, see "2.4.2 System
Locator" and "2.4.3 LEDs of Each
Unit."
As instructed in the above messages, confirm that the XSCF STANDBY LED of the
BB#0 is off. After removing the power cord of BB#0, release the SPARC M12-2S from
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023312

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English