Fujitsu Oracle SPARC M12-2 User Manual

The action to take if the command does not end normally is as follows.
replacefru failed with [Warning:051] as the response.
The unit cannot be replaced because the XSCF is running as master switching,
power-on, reset, or the like is in progress. Wait a moment, and then retry.
replacefru failed with
[Warning:042] as the response.
One of the commands listed below is running. Wait for the command to end,
and then retry.
- addboard(8)
- addfru(8)
- addpowerschedule(8)
- clearremotepwrmgmt(8)
- deleteboard(8)
- deletepowerschedule(8)
- diagxbu(8)
- flashupdate(8)
- initbb(8)
- ioxadm(8)
- poweroff(8)
- poweron(8)
- rebootxscf(8)
- reset(8)
- restoreconfig(8)
- setcod(8)
- setdate(8)
- setpowerschedule(8)
- setpparmode(8)
- setremotepwrmgmt(8)
-
setupfru(8)
- testsb(8)
- setinterimpermit(8)
- sethsmode(8)
While the XSCFU was being replaced, the replacefru command was aborted
because the XSCF was rebooted due to an XSCF panic or other cause.
Wait for the XSCF reboot to complete. Then, execute replacefru again to resume
the replacement work.
Active replacement of the XSCFU
failed because of a defective part (XSCFU).
Prepare a new replacement part (XSCFU) immediately to complete the
replacement. If left unfinished, the failed replacement work may have a serious
effect on the system.
If you cannot prepare a new replacement part (XSCFU) immediately, release the
Chapter 10 Setting Up the System 345

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English