UCM6200 Series User Manual
Version 1.0.20.38
If enabled, UCM6200 will automatically alert this extension when a called party is
available, given that a previous call to that party failed for some reason.
Enable this option to have an external number ring simultaneously along with the
extension. If a register trunk is used for outbound, the register number will be used to
be displayed for the external number as caller ID number.
Set the external number to be rang simultaneously. ‘-’ is the connection character
which will be ignored.
Time Condition for
Ring
Simultaneously
Ring the external number simultaneously along with the extension on the basis of this
time condition.
If enabled, hotline dialing plan will be activated, a pre-configured number will be
used based on the selected Hotline Type.
Configure the Hotline Number
Configure the Hotline Type:
• Immediate Hotline:
When the phone is off-hook, UCM6200 will immediately dial the preset number
• Delay Hotline:
When the phone is off-hook, if there is no dialing within 5 seconds, UCM6200 will
dial the preset number.
Configure the number of seconds to ring the user before the call is forwarded to
voicemail (voicemail is enabled) or hang up (voicemail is disabled). If not specified,
the default ring timeout is 60 seconds on the UCM6200, which can be configured in
the global ring timeout setting under Web GUI→PBX Settings→Voice
Prompt→Custom Prompt: General Preference. The valid range is between 5 seconds
and 600 seconds.
Note: If the end point also has a ring timeout configured, the actual ring timeout used
is the shortest time set by either device.
Enable automatic recording for the calls using this extension. The default setting is
disabled. The recording files can be accessed under Web GUI→CDR→Recording
Files.
To Next Page
Loading...
Need help?
General
