UCM6200 Series User Manual
Version 1.0.20.38
The following table describes the options available when editing the SCA number:
Table 97: Editing the SCA Number
While SCA is enabled, this number will be the same as the
extension number.
Allow Call Retrieve from Another
Location
Allows remote call retrieval. Must be enabled in public hold. By
default, it is enabled.
Alert All Appearances for Group
Paging Calls
Allows all SCA group members to ring when the SCA shared
number is paged. If disabled, only the SCA shared number will ring
when paged. By default, it is disabled.
Multiple Call Arrangement
Allows simultaneous calls in an SCA group. By default, it is disabled.
Allow Bridging between
Locations
Allows location bridging for SCA group. Must be enabled when
using the Barge-In feature. By default, it is disabled.
Configures the notification in the bridge when another party join.
• None: No notification sound.
• Barge-In only: Notification sound will play when another
party join.
• Barge-In and Repeat: Notification sound will play when
another party joins and repeat every 30 seconds.
By default, it is set to “Barge-In Only”.
Announcement
The Announcement feature (not to be confused with Announcement Paging and Announcement Center) is a
feature that allows users to set an unskippable audio file to play to callers before routing them to a configured
destination. Announcements can be configured as a destination in the [Inbound Routes] or in [IVR].
To configure the Announcement, users need to follow below steps:
1. Navigate on the web GUI under “Call Features → Announcement”
2. Click on to add a new Announcement.
3. Configure the required fields Name, Prompt, Default Destination to be used for the announcement.
4. Save and apply the configuration.
To Next Page
Loading...
Need help?
General
