PMS API
The PMS API allows users to use their own middleware to work with PMS systems instead of currently supported
integrations.
Additionally, this API allows access to read and modify certain UCM parameters that current supported PMS
integrations cannot. To use this, users must first enable and configure the HTTPS API settings.
On the HTTPS API settings, permitted IP addresses must be configured. Otherwise, the API will be inaccessible.
On the “Old” HTTPS API settings, permitted IP addresses must be configured. Otherwise, the API will be
inaccessible. Make sure to check “Enable PMS API”.
Figure 274: Enable PMSAPI
On the “New” HTTPS API, users only need to enable the HTTPS API, which has PMS API functionality built in.
For more details, regarding Old/New HTTPS API, please refer to [API CONFIGURATION].
For more details, please refer to online PMS API Guide.
To Next Page
Loading...
Need help?
General
