Queue Auto fill enhancement:
In previous UCM firmware, the call queue has a serial type behavior in that the queue will make all waiting callers
wait in the queue even if there is more than one available member ready to take calls until the head caller is
connected with the member they were trying to get to.
The next waiting caller in line then becomes the head caller, and they are then connected with the next available
member and all available members and waiting callers waits while this happens.
Starting from 1.0.14.x, the waiting callers are connecting with available members in a parallel fashion until there
are no more available members or no more waiting callers.
For example, in a call queue with linear method, if there are two available agents, when two callers call in the
queue at the same time, UCM will assign the two callers to each of the two available agents at the same time,
rather than assigning the second caller to second available agent after the first agent answers the call from the
first caller.
Queue Statistics
Along with the mentioned call center features, UCM offers detailed call queue statistics, allowing system
administrators to make informed decisions regarding call traffic distribution and handling.
Figure 186: Call Queue Statistics
✓ When this option is enabled, dynamic agent login will be no longer
supported.
✓ In case of concurrent registrations, changing agent status on one phone
(login/logout) will be reflected on all phones.
To Next Page
Loading...
Need help?
General
