3. Memory Usage
Figure 299: System Events→Alert Events Lists: Memory Usage
• Detect Cycle: The UCM6200 will perform the memory usage detection based on this cycle. Users can
enter the number and then select second(s)/minute(s)/hour(s)/day(s) to configure the cycle.
• Alert Threshold: If the detected value exceeds the threshold (in percentage), the UCM6200 system will
send the alert.
4. System Crash
Figure 300: System Events→Alert Events Lists: System Crash
• Detect Cycle: The UCM will detect the event at each cycle based on the specified time. Users can
enter the number and then select second(s)/minute(s)/hour(s)/day(s) to configure the cycle.
Click on the switch to turn on/off the alert and Email notification for the event. Users
could also select the checkbox for each event and then click on button "Alert On", "Alert Off", "Email
Notification On", "Email Notification Off" to control the alert and Email notification configuration.
Alert Log
Under Web GUI→Maintenance→System Events→Alert Log, system messages from triggered system events
are listed as alert logs. The following screenshot shows system crash alert logs.
To Next Page
Loading...
Need help?
General
