UCM6200 Series User Manual
Version 1.0.20.38
If enabled, the UCM6200 will play Hold music when there is only one user in the
conference. The default setting is "No".
Select the music on hold playlist to be played in conference call. Music On Hold
playlist can be set up under Web GUI→PBX Settings→Music On Hold.
Select a custom Music On Hold.
If enabled, the invitation from Web GUI for a conference room with password will
skip the authentication for the invited users. The default setting is "No".
Conference Settings contains the following options:
Table 62: Conference Settings
If enabled, the AMI will send the corresponding event when a user
starts or ends talking.
The time in milliseconds of sound above what the dsp has
established as base line silence for a user before a user is
considered to be talking. This value affects several operations and
should not be changed unless the impact on call quality is fully
understood, the default value is 128.
The time in milliseconds of sound falling within the what the dsp
has established as base line silence before a user is considered
to be silent. This value affects several operations and should not
be changed unless the impact on call quality is fully understood,
the default value is 2500.
If enabled, conference audio quality may improve, but system
performance will be lowered.
Users can check the talking Caller IDs in conference control page (UCM WebUI→Call Features→Conference).
The image will move up and down when the user is talking.
To Next Page
Loading...
Need help?
General
