UCM6200 Series User Manual
Version 1.0.20.38
Alert Contact
This feature allows the administrator to be notified when one of the Alert events mentioned above happens.
Users could add administrator's Email address under Web GUI→Maintenance→System Events→Alert
Contact to send the alert notification to an email (Up to 10 Email addresses can be added) or also specify an
HTTP server where to send this alert.
Table 138: Alert Contact
Configure the email addresses to send alert notifications to.
Up to 10 email addresses can be added.
Configure the email addresses to send alert notifications to.
Up to 10 email addresses can be added.
Please refer to section Email Templates
Protocol used to communicate with the server. HTTP or HTTPS.
Default one is HTTP.
The IP address or FQDN of the HTTP/HTTPS server.
Customize the template used for system warnings.
By default:
{"action":"${ACTION}","mac":"${MAC}","content":"${WARNING_MSG}"}
Customize the notification template to receive relevant alert information.
By default:
{"action":"${ACTION}","cpu":"${CPU_USED}","memery":"${MEM_USED}","disk":"${
DISK_USED}","external_disk":"${EXTERNAL_DISK_USED}"}
Note: The notification message with “action:0” will be sent periodically if Notification
Interval is set.
Modifies the frequency at which notifications are sent in seconds.
No notifications will be sent if the value is "0". Default value: 20
${MAC} : MAC Address
${WARNING_MSG} : Warning message
${TIME} : Current System Time
${CPU_USED} : CPU Usage
${MEM_USED} : Memory Usage
${ACTION} : Message Type. Refer to [Table 137: Alert Events]
${DISK_USED} : Disk Usage
${EXTERNAL_DISK_USED} : Disk Usage
To Next Page
Loading...
Need help?
General
